P
PrintablesHelmut
HK416 Airsoft Wall Mount
30% Hexagon infill and normal PLA schould be more than enough. I cleaned the parts and the wall with Ethyl Alcohol before taping.
- Downloads
- 121
- Likes
- 22
- Rating
- 0
All models
Counting matching models…
P
PrintablesHelmut
Birdshot Clip Dan Wesson Revlover (3/6 BBs)
Hi This is a Birdshot Clip for the Dan Wesson Revolver. You might need to bend over the Tip of the Bullets slightly to secure the BBs. I have made 2 Versions with 3 and 6 BBs I would recomend the 3 BB Version because It Performs only…
- Downloads
- 44
- Likes
- 9
- Rating
- 0
P
PrintablesHelmut
Jumper wire Binder (Plug) x16
Just fit the 16 wires inside and use some superglue on the edge (be carefull to not drip the glue on the Pins ;) )
- Downloads
- 19
- Likes
- 7
- Rating
- 0
P
PrintablesHelmut
Airsoft outer barrel extension with 1x or 4x Picatinny Rails
I made the Desing for my AAP01 DMR Build using a 500mm Barrel but I think u can use it for manny other Builds. I glued the Parts together using Kraftprotz 3D Printing Glue
- Downloads
- 16
- Likes
- 4
- Rating
- 0
P
PrintablesHelmut
front gripp A&K M249
I used a switch direktly conectet to the wires of the motor. i used a T Plug in between them but it will only fit verry tightly (optional to tetach the grip from the MG). u will have th bridge the original swith with is located abouth the…
- Downloads
- 10
- Likes
- 0
- Rating
- 0
These are all currently available results.