Counting matching models…
I printed in PLA about 1 year ago, 30% with three walls … still holding up! This thing grips TIGHT, be careful not to bend your downspout. I personally sanded the inside to make it a little easier to slide on.
This requires drilling the bottom of the speaker, using a 5mm heat insert, and then mounting through the provided hole with the mount. The hole I have drilled is centered on the speaker, and measured from the center of the heat insert is…
A bracket for holding the Sabrent 10-Port USB hub (HB-BU10) compatible with mounting on the Multiboard system. It was revised so that it occupies two fewer hexagonal spaces, and provides better viewing and access when mounted in the…
Printed in PLA. No raft or brim. Personally printed in 30% with 3 walls, but could get by with lower %, keeping wall count. May require supports under 90º portion of tabs. Orientation was selected so print would fit on bed.
These are all currently available results.
