Counting matching models…
Remix of Stamos' case for the Raspberry Pi 3. Made for the Libre Computer AML-S905CX-CC (Le Potato) SBC that has the (mostly) same layout as the Raspberry Pi 3+. This is set up with a hole for the IR receiver as well as indentations for…
Great original model, but when I configured negative volume for 1.8mm magnets in PrusaSlicer, the layer above the holes were inconsistent pattern-wise and very thin. Also, the bottom fillet could introduce a little bit of sag. I thickened…
Printed with 0.6mm nozzle using Prusa .20 STRUCTURAL profile using Spectrum PLA Pro and the Prusament PLA profile in PrusaSlicer. No supports needed. These really enhance the dust collection in the downdraft box that I use [Rockler Dust…
Should be able to print as oriented. I used Prusament PETG Galaxy Black with a 0.4 HF Nozzle and the 0.25mm STRUCTURAL profile for the Core One. Other filaments and settings will probably work just fine.
Allows using 1/4" MDF instead of 1/2" ply and 2x4 + shim to set up the Shaper Systainer jig once it has been cut. Works on any MFT-style table top with 20mm holes on 96mm centers. Pictured using a Bora Centipede. Print at least 4 of them…
Made a change to my remix to allow for the nozzle wiper on Gen 2
Made for Multipoint Rails, but Fix Points can also be used
I really wanted to have an all-in-one type console that had an NFC card slot to launch games and this ejector mechanism is great. I combined it with the footprint of the DE10 Nano stack - MiSTer project CUBE case. To keep things very…
I needed to use a right-angle USB cable to keep things clean and not sticking out the sides of the cube, so I made this remix. Print as you did with Side1, and everything should work fine. Made to work with this model: I used this USB cable
These are all currently available results.
