Counting matching models…
A cylinder that raises the valve of the vacuum bag for easier use The tower is placed on the table. Place the fast vacuum bag disc in the bag. Close the bag. Then place the tower under the valve and suck the air out of the bag. 0.4 mm…
Here are two disks that make it much easier to release the air from the vacuum bag using a pump. PLA/PETG 0.2 Layer high The 1.5 mm thick disk is the most stable and takes about 6-7 minutes to print (1.09g) The 0.8 mm thick disk is ready…
Markings can be easily applied to wood or other materials with the parallel marking ruler. Furthermore, holes for drill holes can be easily transferred. the marker works perfectly with the PICA pen. Features: - 90° - mark parallel lines -…
a quick test to check the extrusion/flow factor of your printers print time should be less than 10 minutes Alternate between 2,3 and 4 lines wall thickness if you experience warping add a brim of 2mm inside and outside 0,4 nozzle PLA PETG…
The clip form George is great and I use it every day, so I was keen to improve it further. The weight has been reduced to 0,35g and a clamping mechanism added that doesn't deform the filament. The clip is ideal for vacuum bags. The…
A set for OpenPrintTag consisting of: Base for the sticker Positioning aid for sticking Set of fixing rings for the following spools: Prusament (empty weight ~200g) Esun cardboard (empty weight ~160g) PolyTerra cardboard (empty weight…
A modern case with four compartments for pills and various things. For the closing mechanism 10 neodymium magnets are needed 5x3mm (diameter x height). The magnets are pressed into the holes. For the magnets in the lid, make sure the…
An alignment aid that fits into the holes in the sanding paper of the sander. Insert the sandpaper with the felt side facing upwards and use the holes to centre the sander. Press firmly on the edge and the sandpaper is in an ideal…
These are all currently available results.
