Counting matching models…
This is a simple headphone hook that clamps to your desk and is reversible allowing you to either hang your headphones at the front edge of your desk (using one of the "HP OuterHook*" styles), or back, underneath (using "HP InnerHook").…
There are many other designs that accomplish the same thing, but here's my spin on LED brackets and strip holders that don't require you to disassemble your machine or use screws! Included in the download are straight (0 deg) and angled…
These brackets can be used with any of the Synology DiskStation 2 bay Plus, Value, or J series NAS: DS218, DS223j, DS223, DS224+, etc. Space the brackets 140mm apart and the flange will trap the Synology's feet preventing it from sliding…
I installed some 3/4" PEX-a tubing for a new basement bathroom and wet bar. I wanted an easy way to identify the hot and cold water lines while using white Pex and keep the tubes nice and parallel. Yeah, I could have just written "Hot"…
If you own a newer Rocky Mountain full suspension bike, you'll know the bearing eyelets on the rear shock are a pain in the ass to remove for replacement or to perform an air can service. The official Rocky Mountain tool is $$ and…
This is a replacement goggle strap retainer clip for Giro snow helmets. The tab on the left is a little shorter than the tab on the right. When installing the clip onto your helmet, squeeze the bottom of the clip and insert the right side…
***Works on the Creality Ender 3 Pro and Elegoo Neptune 4 Plus and most likely many other brands of printers that have a similar sized stock spool holders.*** During repetitive retractions and deretractions, a full/heavy spool can start…
"Wet filament is the enemy. An enemy deserves no mercy." - Cobra Dri Karate chop moisture from your filament by combining the heat from your SUNLU FilaDryer S1 and the air circulation and desiccant storage provided by the Cobra Dri! The…
I wanted to mount my KSGER 2.1 Soldering Station (with aluminum case, 87.5mm wide, 38mm tall (42mm w/rubber feet) out of the way to free up space so I designed these brackets to clamp the station to the side of my workbench hutch. Note,…
I designed these baskets to hold desiccant in some cereal storage containers that are the perfect size for storing 1KG filament spools. The top of the basket is taped with double-sided tape and the basket slides on and off so the…
Here's a completely over-engineered T12/T15 soldering iron tip holder. It can be wall mounted to hold tips in either a vertical or horizontal orientation. The round, enclosed portion of the holder flexes outward to make inserting and…
I printed it using PLA+, 2 walls, 3 top and bottom layers, and 25% infill.
The tongue jack on my camping trailer has a flat foot which makes it impossible to position the camper by hand when it it's in the garage. I looked all over for a caster wheel with an 1-5/8" (~42mm) coupler but the only thing I could find…
This is an easy to print desk stand for Ubiquiti's U7 Pro Wall access point. It's low profile; the access point stands only about an inch above the desk so less risk of it getting tipped over by a cat (Kitt, you know who you are). No…
These are all currently available results.
