Counting matching models…
I was tired of having the coal and iron cubes unorganized and sloppy in the marketplace of Brass Birmingham. There are a few box insert prints which have lids which hold cubes, but they didn't work for me. So I designed this from scratch.…
I simply chopped off the rail portion in TinkerCAD. I then modify each one's base height to perfectly level my paver on a crooked desk.
I am playing the newly released Stardew Valley board game, and printing replacement parts. Each of the professions “icons” is on a card, but the player pieces are the generic ones. I wasted to make multiple options for each profession,…
I added 5 degrees to the angle to allow my ERCF mounted cutter to clear my top hat while being mounted on the side. The ideas is that I want a short and relatively straigh filament path from ERCF to my Triedent toolhead, without looping…
I had a Samson Technologies Q2U mic, and the stand was too tall. So I made a small stand so it sits under my monitors. I put holes in it so it can be screwed down if necessary. Included Fusion 360 file. I assume a lot of mic stands take…
The switch is roughly 10mm by 6mm and is used to simply turn the fan off when not in use. Once the print is done I pop off the plate and set it down, then turn on the fan. Within about 3 minutes it has cooled and print pops off, then I…
Strain relief for this bed: https://preciseprinterparts.com/Ender-3--Cast-Aluminum-Bed-With-Built-In-Magnets_p_40.html
I needed to fit Battle Sleeves, which are taller and wider than the tray allowed for. So I made it longer and wider, and a little taller. I then shrunk the coal/iron storage box to fit, and resized lids for both. I also modified the lid…
I needed to mount an endoscope (9.9mm diameter, purchased years ago here: https://www.amazon.com/gp/product/B00JERRES6/ref=ppx_yo_dt_b_search_asin_title ) to the Blokhead fan duct system from Petsfang. Designed in Fusion360, it holds the…
These are all currently available results.
