Counting matching models…
I modeled the 9/40 version to fit my Gen 5 G34, and it should fit the 19, 45, 17, and the equivalent 40 cal models. Based on the feedback I've received it should also work on Gen 3 and 4 9/40 models too. These are designed to clip into…
I couldn't find an umbilical clamp with the size I needed so I modeled my own with editable parameters for custom sizes. You can change the diameter, opening, and thickness of either side of the clip. You can also change the height of the…
Mount to the sides of the bed rails behind the bed with M3 x 8 SHCS. Use M3 x 25 or 30 SHCS for the stops. All my models are free — if you want to support the filament habit, send me a small tip here .
I tried other primer hangers posted here but felt they needed improvements. Primarily, the primer tubes had to be press-fit into the hanger slots which seemed unnecessary. I designed this version so the pick-up end of the tube would just…
Replacement locator pins for Dillon reloading presses and 9mm size cases. These put slight pressure against the case as it indexes and eliminates wobble and cuts down on powder spill. I designed these to fit in my RL1100 and I would…
After printing out another sight pusher I decided I wanted to make a version that was smaller and quicker to print with a captured pusher. I also wanted to use more common hardware and I wanted it to accommodate supressor height sights up…
A simple Arduino breadboard holder. I designed this around the Elegoo Uno and the big breadboard that comes with it. Both the Arduino and breadboard slide in from the side and are held in with clips. I also added a small parts tray to…
This is RockNLol's innovative original design but with the mesh to match the Voron skirts. STL's are for the right side. Copy and mirror them for the left. I didn't alter the Z drive braces so download those from the source and read the…
Hanger for the primer follower on the Dillon RL1100. I assume this will fit other models but I haven't tested it. The inside diameter of the clamp is 14.2 mm. Let me know if you have any feedback. Filament: eSUN PLA
This is a riser and flipper tray for the Shockbottle Hundo Case Gauge. This takes forever to print and you better have your settings dialed in or the interior will be super stringy. Print Settings Printer: FlyingBear Ghost 4S Supports: No…
There are other good models that do the same thing but I wanted one that was simplified and could be stored by simply flipping it over and clipping it on the case feeder. I designed this to fit my RL1100 and I think it'll fit a 1050 but I…
Muzzle end plug for Safariland 63XX for a Glock 34 to adapt to a G19 or G45 length slide. This will let you use the G19/G45 length slide in the G34 holster with or without a light. I've also included a G34 end plug that allows you to use…
I wanted a simple print-in-place one-piece toothpaste tube clip to stop the toothpaste from squeezing back down into the tube at the end. The F3D file includes a user parameter to make the clip longer or shorter. Whatever value you enter…
Parametric Dosing Scoop — Prints in Place, No Supports I needed a way to consistently dose a DIY electrolyte powder mix without reaching for a scale every time, so I designed this scoop. Most of the models I found required printing…
These are all currently available results.
