Counting matching models…
Collet-based system designed for telescoping 1" PVC pipe inside of 1.5" PVC pipe. Designed with center-mounting a flight stick in mind, but should be usable for any application involving length-adjustable PVC piping. Print Settings Rafts:…
DIN rail mounts for combinations of the Duet 2, Duex2, Duex5, Raspberry Pi, Bigtree Tech (BTT) GTR. Heavily inspired by Voron Design, but intended to use heated inserts instead of self-threading screws. Designed to accept McMaster-Carr…
Quick remix of the base for this wireless charger stand.
This is a door hinge for Railcore printers meant to prevent the door from swinging open or shut on its own. It uses a simple pin in track mechanism to lock the door open at 0, 90, and 180 degrees. To move the door between positions,…
Simple duct to replace the stock 25x25mm hotend cooling fan of the Mosquito Hotend with a 5015 blower. Uses stock hardware for mounting. The fan is offset to fit a Railcore II 300ZL using the Mandala Rose Works native Mosquito mount, but…
LED diffuser assembly designed to attach to the 1515 extrusion of the Railcore II. The assembly is designed for 10mm wide LED light strips that can be cut in 100mm segments. Each assembly dovetails into another so that the diffuser…
A mount for any camera using standard GoPro-style 3 lug mounts that bolts to the roof rack hardpoints of a VA WRX/STi. Presumably fits other Subaru models using the same hardpoints. It captures a really great perspective just above the…
Replacement keycap for the Thrustmaster Cougar MFD. You will still need the original membrane cap half of the button for this to work; this simply replaces the hard plastic keycap. The button face is slightly concave on this model. Print…
Mount for the LDO Orbiter v1.5 on the Railcore. Tested with the MRW native Mosquito mount. Two versions: Mount for the Orbiter only Mount for Orbiter with additional hardpoint for the 5015 Mosquito Duct Two M3 heated inserts required for…
This is a major redesign of the XRAT (X Rail Alignment Tool) for the Railcore II. The basic principle is the same and the same operating instructions apply, but there are a number of improvements based on feedback from the community:…
This is a remix of the standard Railcore II foot edited to add height adjustability to compensate for uneven or bowed work surfaces. Use three standard Railcore II feet with this assembly in one corner, then set the height of the adjuster…
The mounting clips that come with this light don't really secure the light to the tank very well and I've had a couple of scares with the light nearly getting knocked into the tank as a result. This slips over the factory mounting clip…
BQE Bandolero trunk with increased depth to fit a Walksnail Avatar VRX complete with Immortal T mount and an even more ridiculous air scoop. Increased from 8mm to 12.5mm total height. Supports required. Based on dimensions from the OEM…
A simple hanger designed to store flex plates on the side of the printer when not in use. There are two variants: one with through holes sized for the 5.3x51.mm BOM heated inserts and another for McMaster P/N: 94459A130 4.7x4.3mm inserts.…
NOTE: This thing has been semi-superseded by the XRAT 2.0 . The old design still works fine, but if you're working on a new build, I would suggest considering the 2.0. That said, it is a slightly harder print and does require additional…
This is a small mount for the Armattan Tadpole 3" intended to hold a stock TBS Crossfire dipole antenna at a 120 degree bend. Inspiration credit obviously goes to Mr. Steele. While this is definitely less efficient than a straight dipole…
These are all currently available results.
