Counting matching models…
Full size birdshead style grip for NAA revolver chambered in 22s. Crazy tiny little wheel gun, this makes it possible to hold onto it. :) Screw holes are sized for M3 screws and nuts, print flat side down with copious support. Inletting…
These bracket pieces are sized to work with stock Sched 40 PVC pipe, I bought 5' sections and used them as-is. The brackets I just popped in, the 'foot' pieces I wrapped with masking tape to keep them secure. Target hangers are made from…
After pinching my palm for the last time pumping up my 1377, I went looking for an easier to grip option. I considered a wooden grip, but I wanted to keep the cost lower. At some point in my wandering I acquired a model of a Crosman Pump…
Included are three apertures corresponding (more or less) the sizes offered by Williams for the WGRS-54 peep sight. If printer tolerances are OK, it'll thread right in. These should fit any other peep sight that uses the same 7/32-40…
I got tired of my handguns sitting on the tiny shelf in my gun safe, and whipped this up to move them onto the inside of the door. The idea is simple, use off the shelf magnets (in this case, 1 1/4" diameter, 1/4" thick with a 1/8"…
In an effort to use up some empty space on the walls of a storage cabinet, I whipped up this bracket. It uses three Neodymium magnets, 75lb rated, and easily holds a 3lb Ruger Charger in place. The exact magnets and bolts I used are in…
My Scorpion looked dumb on the bottom of the safe, being all short like it is. I noticed that I had a pretty big gap above the barrel rest and a shelf and it fit nicely there so I knocked up this holder. It's got pockets in the back that…
I bought a used scope and it didn't come with caps, so I made these. I had 3mm elastic cord on hand, so that's what I used. I did chase the cord holes with drill bit to loosen them a little. Make sure you tie the knots so there's a little…
These are all currently available results.
