Counting matching models…
The original pins I found (they are since deleted) had tiny holes in the middle that made the cross-section a little strange and were a bit faceted, so I copied the angle of the pin slot and redesigned the rest using max facet cylinders…
I resized them to fit the 1/4" and 3/8" connectors on my under-sink water filter. Print Settings Printer Brand: Creality Printer: Ender 3 Rafts: No Supports: No Resolution: 0.2 Infill: n/a Filament: ZYLTech PLA Black Category: Kitchen &…
The brackets from atomotec were a little too big for my cage, and when I scaled them down to 85% so they fit one of them broke because it wasn't strong enough. I loaded the bracket into Tinkercad and added 2 mm to the top and sides and…
The original wasn't long enough to reach the release tabs on my 2003 Tahoe. So I lengthened the tabs in tinkercad and reprinted it. I ended up pushing them in with a narrow open ended 11 mm wrench, then once they were both seated I put a…
These are all currently available results.
