Counting matching models…
Do you have a filament spool with a beveled or rounded edge that keeps slipping off the spool holder during printing? This compensation middle ring is the simple solution. Creates a flat and consistent surface Easy to install - simply…
California 1972 license plate for a new 3D Sets Model 17: Sakura 240. Print either with filament change based on layers or using MMU or AMS. UPDATE 2024-05-11: Added 3MF for PrusaSlicer (filament change)
Horizontal stand for the Dukedoks Cramer Truggy , ideal for servicing such as differential repair or for display/storage. The car is held in place by holes for the chassis screws and by cut-outs for bumpers. You will need some M3x16…
The original case used the foam insert from the Ledger Nano S package. New Ledger version - Nano S Plus - doesn't come with the insert, so I made one that fits this great case. Settings for best results: TPU 1 perimeter 10% gyroid infill…
Adapter for pneumatic fitting for bowden tube (e.g. from your filament dryer) that mounts on top of the original Prusa filament guide. Adapter uses the “filament resting” holes on the filament guide as mounting holes for screws and it has…
Case for Atomos Ninja/Ninja Ultra based on Rugged Box by Whity. Fits following: Atomos Ninja/Ninja Ultra monitor-recorder NP-F battery (up to 7800 mAh) monitor mount SSD (with Master Caddy) cables etc. You will need 6× M3x30 screw (or 4×…
Cable mount with 6.5mm hole (e.g., for UTP CAT6 ethernet cable) for better cable management on your walls or ceiling without drilling. Just use hot glue or double sided tape. Key features Fits cable of 4.5-6.5 mm diameter, but can be…
I saw that the screw holes on the TPU Chasis Front Bridge on my Cramer Truggy were getting a beating, so I thought I'd make a cover that would protect the screws holes and look good at the same time, similar to the rear spoiler. PS: I…
Snaps onto the top of the frame and accepts 1/8" bowden adapter (pneumatic fitting). Recommended to be printed with at least 3 perimeters and 20% infill to make it strong, optionally with organic supports for the best possible hole.…
Water level indicator with smaler hole on the right side that fits the floater more nicely.
Remix of this simple but great pulley using 6700ZZ (10x15x4 mm) bearings instead of the original 5x11x5 mm. See instructions in the description of the original model .
Motor pinion flange with three holes instead of four. Fits this motor: https://www.bighobby.cz/stridavy-elektromotor-3530-1700kv-bh-power-v2/
Spacer for loose Sennheiser Momentum 2 earcups. It is 1 mm high, but you should try different heights. My sweet spot was 0,8 mm, yours can be different. Printed with Fiberlogy FiberFlex 30D, maybe 40D would be a tiny bit better. PLA is…
A simple GoPro mount for the 3D Sets Mogster with retro seats (models 20 and 21). It easily slides into place: tilt the GoPro (you may need to move the seat forward), insert the mount, then straighten the GoPro and secure the mount by…
These are all currently available results.
