Counting matching models…
Small enclosure for the 4x4 Matrix Keypad. The case is 78 mm wide and 77 mm long. The total height of the case is 21.5 mm where the bottom is 20 mm. Hole for wires at the bottom, being 10 x 20 mm. Lid is snap fit, so you it can be a bit…
A helper tool to keep your gift wrapping paper in place while wrapping gifts. This is the first version of the model, and it is not perfect. I plan to add a few more improvements to this model as I get them completed and tested,…
Small enclosure for the Waveshare Barcode Scanner Module Lid is snap fit, so you it can be a bit hard to take off ones first assembled. This case assumes you trigger scanning using commands as there are no physical access to the trigger…
Enclosure for the Waveshare 4.3" DSI Capacitive Touchscreen Display . Assembly The screen is mounted using four screws from the bottom of the case. The lid it self is pretty much just cosmetic to close the box. Printing instructions…
Small enclosure for the 3x4 Phone-style Matrix Keypad. This is made for the model they sell at ThePiHut ( 3x4 Phone-style Matrix Keypad | The Pi Hut ). I had to change the distance of the pins on the short side down to 45 mm even though…
Models are structured by the diameter of the jar. The height is for the base model. Total height of the jar is H + 14 mm (see image below). Files are organized in folder by the diameter of the jar, there you will find the lid and all the…
A simple holder to mount your Raspberry Pi and Breadboard/experiment board. Note: It's not a snap or tight fit as it fits multiple different breadboard. Breadboards with a size up to 57 mm to 165 mm. The Raspberry Pi is mounted with…
A simple open cable grommet/cable protector for holes in e.g. desks, tables and so on. No lid because my main goal was not to hide the cables/hole, rather just protect them from the sharp wooden edge. The files are grouped by the height,…
Just a simple holder for rods of different diameters. These are designed with the exact fit of the rod, so it would be a press fit to prevent the rod from rotating. We mounted ours with double sided tape, but added a mounting hole in the…
The case came with just a few small compartments. As I use one of these for small electronics I needed more of the smallest case. This is for the size 45x45 mm, but the actual size of the box is a bit different. Bottom is 45x45mm and the…
These are all currently available results.
