1 / 2
Barcode Scanner Module Enclosure
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution
Small enclosure for the Waveshare Barcode Scanner Module
Lid is snap fit, so you it can be a bit hard to take off ones first assembled.
This case assumes you trigger scanning using commands as there are no physical access to the trigger button on the board when the enclosure is assembled.
Printing instructions:
Print the lid with the top down and the bottom with the bottom down. Supports might be needed for the holes on the bottom side of the case depending on the printer.
The model in the picture is printed on a Bambu P1S with:
- Filament: Bambu PLA Basic
- Infill: 15%, Gyroid
- Supports: No
- Adhesion: No