Counting matching models…
I designed a version of this game that prints easily without supports or bridges. Assembling is fun and feels great. The honeycomb structure allows for many different configurations with just one chair design. I printed the chairs from…
Very important note! Only open the power supply if you know what you're doing! The capacitors can store a great deal of energy for a very long time, even after the power supply has been unplugged. By that, I mean enough energy to kill…
The clip on my Skoda Fabia has broken for the second time. I drive on a route where the sun often hits from the side/front. The cover, metal clip, and screws are reused from the original. The model requires a support structure and should…
I need a simple, small target to set up for the uhltimate disc shooter. It consists of two parts and can be easily assembled. It simply fits together securely, no glue is needed. The two colors can be created with a simple filament change…
I want to pre-sort the parts for my Core One kit before I start assembly. Therefore, I copied the components from the assembly instructions into a single document. The parts are sorted by construction steps and also by package. This…
I bought a Gardena berry picker but didn't have a Gardena telescopic pole. I did, however, have a paint roller extension pole. So, instead of the adapter for the Gardena system, I printed a different adapter. This one attaches with the…
It is a clip for the Tool-Check Modular from the Wera Advent Calendar 2024. It can simply be printed out and attached. I printed it with PETG, with 4 wall perimeters and Gyroid 20% infill.
The lightning bolt consists of 3 parts. One handle and two lightning parts. Simply put them together and you're done.
This is an add-on for the Tool-Check Modular from the Wera Advent Calendar 2024. It can be easily inserted into the existing rail. It is suitable for the following S11 LED flashlight. (RovyVon A5) The head of my lamp has a diameter of…
Threaded rods sometimes sag slightly during curing if the hole has become larger than intended. To counteract this, I designed these holders. The holder is designed for an M10 threaded rod. Please let me know if other sizes are needed.…
The wet wipes pack holder can be attached to any metal surface. You also need two magnets 40x10x5mm Neodym . I glued the magnets in with two-component glue. I used “UHU Plus Endfest 300”.
I made another ESP32 camera housing with attachment to the aluminum profile of the Prusa Mini. The USB cable is routed downwards in the aluminum profile. I printed everything with standard settings without supports but with 3 perimeters.…
If the silicone cover of the Woom Glug bottle is broken you can replace it with this cap. The silicone must be completely removed. Then the printed lid can be reattached with hot glue. At least that's how I did it and it works.
It consists of one side of an empty Prusa spool and a holder for 250g spools. It works with the Prusa Mini Base without longer feet. The screw is simply pressed into the side of the spool instead the cardboard roll. The coil is held with…
I installed the FollowMe on a Woom 4 that has a mudguard. The mudguard clamp no longer had a place to attach, and the FollowMe bolt was too small, so I 3D-printed an adapter sleeve. You have to be a bit careful when sliding it on so you…
These are all currently available results.
