Counting matching models…
The original "G2E PG7 Mount SB2040 3010 V1.5.stl" was not a single, solid design - parts of it were floating. I made some small tweaks to the Fusion 360 file (included) to make it a single, printable piece.
Wanted to use the space below my garage door rails to hang misc wires, oscilloscope probes, Bowden tubes…whatever. These work! So far only printed in CF PETG. Under really heavy load (like a 50 foot 3-prong extension cord), they sag, so I…
I was building my second Vitalii TAP and realized I didn't have any more of the correct opto sensors for it. But I did have a few left over from my purchase of 5 cheap ones a few years ago. So I modified his Wired Optical Sensor Mount.stl…
Wanted to mount my AX-8PTC on the side of my equipment stack, and Nicolas Massé's design was a great start! You can mirror the design in your slicer if you want to mount on the left side. Fusion .f3d design file included.
The power switch is normally in the back with the power inlet and fuse, but I like having an illuminated power switch near the front for convenience, and this 20x13 mm switch was what I had laying around. I wire them in series so both the…
The CB2 heatsink is symmetrical, so I was able to make a simple mount with two identical parts. Printing: Filament type not super important, but I used ABS since it's more heat resistant. The STL is already oriented correctly for…
The bed for the Voron Trident I'm building allows for two thermistors - the one that comes embedded in the heating pad and an independent one. I liked @methylene67_166296's design so I added a hole that allowed hard-wiring each thermistor…
I needed to mount an XL4016 DC-DC converter into my Voron, so I took this DIN mount and sorta turned it inside-out. I put a few non-conductive washers in between the XL4016 PCB and the mount since the bottom of the PCB is not perfectly…
Our house has a lot of these Hunter-Douglas blinds, each one of which gobbles down 12 AA alkaline batteries every 6 to 18 months. I finally got sick of it and designed a holder for a five 18650 Li-ion stack so when they are out of juice I…
These are all currently available results.
