Counting matching models…
I remixed the excellent Rugged Box to hold my mobile, temporary installation Meshtastic box. It currently holds 2x 18650 batteries in parallel and has space for 4 magnets so you can stick it to a steel surface. The plate is modeled for a…
I created this model to attach a solar panel to my outdoor Meshtastic router. Build materials: Cheap outdoor enclosure 120x90x70mm RAK Green Power Module RAK19007 RAK4631 Big ty-wraps for the mast mount 12v solar panel - not sure about…
I added a Truma Ultraheat to my caravan, but the control panel was exposed from the rear. The original switch has a cover plate, but I needed something bigger to cover the original switch and the ultraheat controller.
This battery has very exposed battery terminals where regular covers don't fit it well. These cover them nicely. I used 16mm2 wires, much bigger probably won't fit.
You can use this parametric model to create a fitting insert to drop into a parametric rugged box by Whity; just copy the parameters from the box to the insert in Fusion360 and you're good to go to add your cutouts! For an example, I used…
Our muncipality recently switched to collection of PMD trash in bags. To prevent them blowing into the street, I made a hook that I can ty-wrap to a lamp post. The rear follows the curvature of the lamp post. Best printed in something…
- 60mm fan - 3mm heat set insert - use ABS or maybe PETG
There is just a single parameter to set, set that (BuitenDia) to the external diameter that you need. The resulting print should fit on both the inflate and the deflate side of the Flextail Max Pump 3. It prints without support, just make…
Based on the wonderfull parametric rugged box, I created the insert to neatly house the Icom IC-20SR PMR radio's and the USB-C charging cables. I added a bit of foam stuck to the lid to keep them from rattling (they won't fall out but…
These are all currently available results.
