Counting matching models…
Wanted a better mount than the one included with the HL-X Pro, found some files that would work but are too big and intended for older model, bigger tape switches. The new one is quite a bit smaller and doesn't have the bump(?) on it. So…
Instead of screwing right through the top hole, screw in the screw first (I recommend a replacement M3x10/12) and leave a gap for the slot in the shute. the screw at the bottom aswell as the top slot, It holds in place pretty well.
Wanted a convenient place for our Vacuum attachments, so whipped this up real quick! Convenient slots for both the included crevice and brush tools. Should fit any vacuum with a 33mm diameter shaft, but your results may vary, .STEP files…
Original design credit goes to peep111 I liked the original idea, but it had a lot of cutouts for accessories I didn't have/need, so I trimmed it down. Original also doesn't have any way to mount to a wall, as it's meant to adapt to an…
Wanted an angled desk mount for my stream deck that looked nice and wasn't too bulky. So I whipped this up. Uses two screws to mount underneath the desk. Picture differs from the actual design slightly; The design pictured has the back…
These are all currently available results.
