Streamlight Protac HL-X Pro Tape Switch Rail Mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Remixed tape switch mount for the HL-X Pro.
- Rating
- 0 / 5
- Likes
- 16
- Downloads
- 109
- Makes
- 0
- Views
- 889
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Mechanical Parts
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Wanted a better mount than the one included with the HL-X Pro, found some files that would work but are too big and intended for older model, bigger tape switches. The new one is quite a bit smaller and doesn't have the bump(?) on it.
So I remixed this one from thingiverse: https://www.thingiverse.com/thing:4799403
Hardware Required:
M5x30 Bolts x2
M5 Nuts x2
Install notes: the tabs for the base are a tight-ish fit. Prefit before putting the switch on, to “work” the slots out a bit.
The slots for the nuts are a super tight fit. Best way to seat them into place, is to butt the ends together (as if the base were in place) , push a screw through into a nut onto the other side, and then continue threading to “pull” the nut into place. You may have some luck scaling the model a tad, but this hasn't been tested.