Streamlight Protac HL-X Pro Tape Switch Rail Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remixed tape switch mount for the HL-X Pro.
- Ocena
- 0 / 5
- Polubienia
- 15
- Pobrania
- 107
- Wydruki
- 0
- Wyświetlenia
- 882
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Wanted a better mount than the one included with the HL-X Pro, found some files that would work but are too big and intended for older model, bigger tape switches. The new one is quite a bit smaller and doesn't have the bump(?) on it.
So I remixed this one from thingiverse: https://www.thingiverse.com/thing:4799403
Hardware Required:
M5x30 Bolts x2
M5 Nuts x2
Install notes: the tabs for the base are a tight-ish fit. Prefit before putting the switch on, to “work” the slots out a bit.
The slots for the nuts are a super tight fit. Best way to seat them into place, is to butt the ends together (as if the base were in place) , push a screw through into a nut onto the other side, and then continue threading to “pull” the nut into place. You may have some luck scaling the model a tad, but this hasn't been tested.