Counting matching models…
Just a basic remix of johnniewhisky's OG cable chain and Vijit's remix to reduce some filament use. For all other parts in the diagram, check out their files. The cover should print just fine without supports as they are (vertically).…
To vent exhaust air in a specific direction if you have your desktop up on a table like me. Reduced noise by ~3db (roughly, measured on smartphone at where my head usually is) idle and ~6db under load. Also heat isn't dumped near my face…
The original design has a large flat bottom, which for some reason would always sag downwards for me, sometimes colliding into prints. This remix minimizes that bottom surface such that the sag points are eliminated. The bottom is also…
No supports. Tiny. No collisions. Glue may be needed as M3 nuts have ~0.3mm variance depending on manufacturer.
Update: Added a newer version to mount the probe lower. Probe wasn't long enough in the default version to function. Most users should use this new ("Low") version. Mount for 8 and 12 mm diameter static ABL probes (capacitive & inductive)…
Remixed from R31L4ND's E3D V6 Hotend Mount for the Sapphire Plus to better support the Mosquito/Spider & clone hotends. The collar and BLTouch mount have not been changed - feel free to re-use R31L4ND's. BLTouch: define…
Mount for 8 & 12 mm diameter static ABL probes (capacitive & inductive) for the Creality Ender 3 V2. Requires 2x M2.5 or M3 bolts at least 5 mm long. If your probes came with washers, those may not fit, just exclude them from…
Original description - check his page for detailed license terms. "I have IKEA TROFAST rack in the middle of my room with no wall behind it. Stock boxes rails has no stoppers and slides both ways - I wanted them to just stop when moved to…
Motivation I wanted to mod the ultimate Ender 3 (Pro), so it had to have: Octoprint/Klipper, so a Raspberry Pi and a LM2586 format buck converter). Dual-Z Axis Motors/braces, so the PSU must be relocated. Some storage drawers to store…
Usage tips: place the main earphones inside route cables out any hole and wrap around to other end stick the 3.5mm jack into the center Category: Audio
Remixed mag76bh's remix to add cable chain functionality to also add 2x40mm fans to cool stepper drivers. What's different from other fan remixes? This version mounts the fans at an angle so that it completely fits within the same…
Drop BMR1 stand 40 Degrees. No supports needed. All pieces should just friction fit together, but you could dab some super glue if you're worried. Make sure it's fully dried before you attach it to the speaker, or the glue may spread and…
Mount for 12 mm diameter static ABL probes (capacitive & inductive) for the TwoTrees Sapphire Plus (and likely S). Uses OEM mounting points and bolts (M2.5 or M3). If your probes came with washers, those may not fit, just exclude them…
Recommend slightly higher infill, e.g. 30%. Supports not needed. Try to use self-tapping screws within 7mm total shaft length. Current model uses a inward-drafted 2mm diameter hole, with modelled penetration depth up to 6mm. Modify with…
These are all currently available results.
