Counting matching models…
UPDATE: I accidentally left “section analysis” on. So if you set height to more than 6U, it showed only a bit. It was confusing, now fixed. New way to tackle lifting corners. I tried mouse ears and all. Nothing really works 100% and takes…
Honestly this remix of this design is way better than mine original. https://www.printables.com/model/659216-gridfinity-tweezer-box-angled-entry Rest your tweezers with style. Gridfinity Yeah, by Zack Freedman - gridfinity.xyz. Box has…
Made with my parametric gridfinity box . I've seen these in the wild. But I was not sure about clearences and they seemed to be higher on sides than on top, which makes inserting swatches pain. By elevating the middle, you have no problem…
It is gridfinity . Based on my Fusion parametric gridfinity model so it comes with nice magnet holes, corner bases have them covered with 0,2mm to prevent edge lifting, 0,5mm clearance so it sits nice. 7 slots for chalk, just wide enough…
I did this to prevent oil dropping everywhere. Works with 1/2" ratchet, but that is needed only to loosen it a bit. Then just loose it by hand and let it drip. I printed it in Prusa Orange PETG because that is what I had on hand. So far…
These are all currently available results.
