Counting matching models…
Pretty straightforward. Three screws, strong, and support-free print. I needed a hanger for my compressed air hose that worked for the side of my shop cabinets, and this is what I came up with. It's low profile because I have limited…
Had this hanging on my front door for almost two year. I know it worked, because I didn't get an unwanted knock the entire time, and since I removed it to repaint the door, I get several per week. Don't remember where I got the phrase…
This print is in two parts specifically for support-free printing. It's dovetailed for strength and easy assembly. I use CA glue or epoxy for assembling these; both work fine, since the dovetail joint counters gravity when hung on your…
Easy and fast, no gimmicks or fancy mechanisms here. Just pressure fit top over bottom, vase mode, no supports. Not much else to describe. I print them in PETG with a 0.6mm nozzle at 0.28mm layer heights. Takes under an hour for both…
I have printed the original probably 20 times, great model. I needed a version of the ¼-20 with a captive nut nearer the base, so here we are. Still no supports needed. Add your filament change gcode at the top of the opening for the…
I could never find a fan bracket that fit fans in the original overhead position for tall heat sinks on the 2208 and up drivers. They seemed to be all from the side or require replacing a chunk of the bottom plate with another printed…
Tablet mount offset to one side, intended for 2040 extrusion. This was designed for a tablet approx. 239 mm in length. I have included two versions: A split version that allows for printing in parts and assembly with epoxy and screws.…
V-Slot Covers / LED Diffusers / Channel Wiring Concealment Multiple lengths and self-supporting print options No supports required Included STEP file containing all variants for customization Optimized for 0.4mm nozzle Flush with…
If you're a household where more than one gamer has a Steam Deck, this helps store or display them in an efficient, compact manner. My wife and I both use a Steam Deck but don't like the clutter of them laying out on the end table and…
Not a whole lot going on with this model. It's two mating parts, one on either face of a piece of ¾" / 23/32" / 19mm plywood. It should be large enough internally to feed the male connector end through. I used a bit of CA glue to connect…
Easy enough to print, no supports needed. I used PETG as I do for all shop prints. Screw holes are countersunk for either wood or drywall screw mounting.
After breaking 4 of my tanks by tipping over the Mixx with the Ares 2 tank attached, I knew I had to make something, since regular vape bands don't fit these setups. Should work with at least a few other 24mm tanks on that mod. Printed in…
These are all currently available results.
