Counting matching models…
Just a simple combination of spoon and fork, a spork. Perfect for camping on the campsite or backpacking in the mountains, space-saving, light and yet robust! The hole at the end of the handle makes it easy to attach the spork to your…
Simple calibration (not cube) cube each surface should be exactly 20 mm away from its opposite surface. Otherwise you know in which axis your problem is (or you have resized it)
Jeden Tag kann man das akutelle Datum legen, inklusive Wochentag. Beim drucken darauf achten den Farbwechsel des Filaments auf die richtige höhe zu setzen, die zeichen beginnen bei z 1mm, also auf die nächste schicht den Farbwechsel…
…print it as you like… Use not TPU!
This handle is made for a bar with a diameter of 27 mm, but can easily be adapted in fusion360 (or other CAD software) if required. I used ePA to print with 15% infill, but do what you want to do. Have fun with it!
I strongly recommend to print it in TPU, rather too high temperature than too low. Tapping screws are usually used for fastening. I assume no liability for anything, use at your own risk! image: Von Biezl - Eigenes Werk, Gemeinfrei,…
Holder for this socket for 2020 extrusion. The powersocket can be rotated 180° , that the switch is at the top side. The holes are made for M3 screws. I recommend petg , it's stable enough! (I haven't tried anything else either) Thanks to…
Printed in PETG works well! I made the pillar with 100% infill! I have''t noticed a use case for the square between the "disks" (like in FlipchartPaperHanger.3mf) so I recommend the stronger version.
I made/used it so that i could screw the motor drivers onto a wooden board without the solder joints pressing into the wood. It also raised the drivers slightly so that they were protected from moisture on the board The open side should…
These are all currently available results.
