1 / 3
TMC5160 Pro mount/spacer
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial
I made/used it so that i could screw the motor drivers onto a wooden board without the solder joints pressing into the wood.
It also raised the drivers slightly so that they were protected from moisture on the board
The open side should be at the cable-screw-braket, because these solder joints are the biggest.
You can use the four holes in the corners if you have fiting screws, or the two holes for countersunk heads.
I have the MKS TMC5160 Pro V1.0, but i think other branded should fit too.