Counting matching models…
Just a simple plug to plug front bumper holes if they were drilled in your car's front bumper and you don't need them. I've been running two of these in the front bumper of my Impreza since 2017 printed in black ABS. Unfortunately I don't…
I don't remember anything about this part. Someone asked for it, last (and only) time I printed it was back in 2017 to install a dashcam. Category: Hand Tools
Do not print this face down as shown in the preview. Print it in the orientation shown in the photos below. The .stl file in the current models folder is in the best orientation for printing without supports. This is the clip side of a…
Other shaving brush stands I tried were either too short to hold the brush over the soap dish, or the gap between arms holding the shaving brush were too far apart, so I designed my own. I have uploaded the .f3d file and a .step file so…
The original file from Matticus Finch is very well done, but needed some small tweaks to fit what my wife needed on her bike. This remix allows all three screw holes to be used at once on a Trek Allant+ 8 and accommodate the slightly…
Print this on end with narrow side down. Screws to the bottom side of the top tube on a Trek Allant+ 8. Use velcro up to 1" wide to secure bicycle pump in holder. Clip is designed for a pump a little over 1" in diameter.
Mounts to the wall using four #8 screws. There is enough play that you can mount it to the wall and then slip the modem into it. The file labeled print orientation is oriented to print without any supports. I used PETG at a .3mm layer…
This is a funnel end that is intended to fit over 3/4" SharkBite brand PEX to make an inexpensive Christmas tree watering funnel. There are small channels in the end that allow air to escape preventing a column of air from forming in the…
Printed using concentric solid infill, black ABS. These plugs pop right into the handlebar ends of a 2010 Kona Jake the Snake.
Simple insert to take the 2017 Subaru Impreza cupholders down to a size that holds a normal sized cup effectively. Print Settings Printer: Folgertech 2020i3 Rafts: No Supports: No Resolution: 0.2mm Infill: 15% Notes: Print with larger end…
Print this without support with the countersunk side of the screw hole on the bed. Clip to the top. Screw to the fender mount with pretty decent torque, but don't strip out the hole in the bike. This clip holds either a Bontrager Flare1…
Completed mount to mount a Bontrager Flare R City Rear light to the rear left fender mounting point on a Trek Checkpoint ALR5. This mounts the light right next to the rear brake disc. This has been tested on a 2018 Checkpoint, should be…
This holds a shaving soap, brush, and safety razor in one footprint to take up less space. Prints well in PETG sitting flat on its back at a .3mm layer height and no supports. On a Sovol SV01 I have to print with it turned at roughly a…
This remix allows you to tension the belt without putting the tension in the belt back through the z-axis linear guides. The tension in the belt becomes a compression force on the x-axis linear guides through the two screws that thread…
These are all currently available results.
![Large Bicycle Bottle Cage [Remix]](https://media.printables.com/media/prints/166951/images/1553215_f0b1ad11-af6e-41f6-b546-d86a74fe5e74/20220410_090749.jpg)
