Counting matching models…
New V3 with grooves for grip, angle markings, and modified dovetail channels! Slightly tighter clearances as well for less play. New V2 dovetail design added! Slightly flexible filament like PETG recommended to join the pieces without…
Fully 3D printable pliers-style multitool styled after the Leatherman Charge Plus ( https://www.leatherman.com/charge-552.html ) No screws or springs required, some filament is used for hinges. Assemble the Pliers LAST for an easier time.…
This propeller toy takes flight at the snap of a finger! Simply grip the handle between your finger and thumb, then give it a quick twist and watch it soar. Cura Print Settings: Orient with handle pointing up 0.2mm layer height or less 2…
Very close copy of Oakley Holbrook right side arm
This wrench selects the ratcheting direction based on how you first turn it! Simply push the reset button before or after use to return it to the neutral position. Based on my previous design that featured a lever instead of a button.…
This is a badminton racket, sized proportionally to the original Lucky 13 figure. It prints in two halves and needs to be glued together to form the full racket. It slips right into the Lucky 13 gripping hand. Print settings are the same…
Styled after the Thyrm Switchback line of flashlight accessories, this 3-piece print goes together to give your Convoy S6 a functional pocket clip as well as a finger ring for a secure hold in tactical (or tacticool) situations! Assembly…
3D printable Sheriff keychain with rotating cylinder! Print with at most 0.16mm layer height to keep detail and ensure detents are effective. Prints in two halves, alignment pegs are optional but can help when gluing. Proper alignment is…
Version 2.0 is here! This socket wrench chooses the correct ratcheting direction on its own when you start using it! All you need to do is reset it with the switch afterwards. Gone are the days of ratcheting the wrong way! Printed with…
A straightforward badminton shuttlecock modeled in real scale. For decoration purposes only. 16 feathers needed to form the entire shuttlecock. Front and rear rings snap into place outside and inside the feathers, respectively.
Draven's spinning axes to be 3D printed! Image preview was printed with 0.16mm layer height. Print inner and outer blades with supports. Part fitting has 0.15mm clearances, make sure your printer is accurate to allow the blades to spin on…
If you want to enable your Kronos to fire short darts but don't want to pay for a kit, this insert does the job. Plus, the modification is completely reversible and does not require permanent changes to your blaster. Only 3D printed parts…
These are all currently available results.
