Counting matching models…
This is a remixed version of the great model made by SilentWoof on thingiverse with a few extra bits included. I've reshaped the main mount body to provide a cleaner look with less sharp corners. The optional ball joint is remixed from…
I made this remix to make it easy to print multiple snowman hats at the same time. The hat is split into three parts: top - suggest printing in black middle - use an accent colour bottom - print in black There is a small recess on the…
USE AT YOUR OWN RISK - Sounds a little dramatic, however if you use this mount then the end-stop switch will no longer trigger. Instead, the ADXL will crash into the motor cover. To work around this, I just triggered the end stop myself…
I really like the original model and have used it a few times. This is a remix I put together for the Bluey 5-in-1 Playing Cards. Internal dimensions are (L / W / H): 129mm / 90mm / 23mm
This is a remix of a design by Roxy2020 Washi Tape Dispenser by Roxy2020 - Thingiverse I like the simplicity of the original design but it required lots of supports. To avoid this I sliced the model up and added some 12mm M3 screws. This…
This is a case that I remixed from D1 Mini Pro v3 IR Case by Ryukenden . I use it with ESPHome to connect to the pulse outputs on my Eastron SDM230 electricity meter. This is running a tweaked version of HA-Glow Project (ESPHome) to have…
This is my remix of Maple Leaf Makers Modesty Mesh for my Voron V0. The two key changes I've made are: It has a thicker border to them from bowing once installed. The clips are offset to allow running wires between the chamber and the…
I modelled it from scratch so not exactly the same dimensions as the original model. The model uses 608 bearings (8x22x7mm). I've extended the “hood” side so that it was able to be clamped to the timber. Also added centre markers. Its…
I made this remix to be used as part of my Home Assistant Glow setup. It uses a Wemos D1 Mini v2 board with soldered on headers, the “Lid” model has extra height to allow for the connectors to fit and then wires to pass through the lid.…
These are all currently available results.
