10 models
This is an upgrade to my previous mod to eliminate the aluminium extrusion from the x-gantry. You can run with just a single rail or with 2 rails screwed together by aluminium blocks. A single rail can save a lot of weight, while also…
Remix to use without a bolt. Just tie a not in a rope and put it through the ball. I cut out an extra cylinder so the knot would not stick out, but disappear into the ball. Printed with fuzzy skin and gyroid infill in Cura. Used support…
The original ceiling hook could slide out of the base. I wanted to hang my body weight from these, so I didn't want to have that risk. I redesigned it from scratch in FreeCad and tried various solutions. This final design was the…
Simple cap to seal a caulk tube after use so it doesn't dry out. Category: DIY
Drop-in replacement for 608zz bearings in top lead screw mounts. These do not restrict the movement like a bearing but do prevent the lead screw from rattling around. 22mm OD, for 8mm lead screws. Category: 3D Printer Parts
I designed this hotend sock for the Phaetus Dragon because I wasn't happy with the original at all. It is too thin It is quickly destroyed by high temperatures It isn't good for air flow I couldn't run my 4028 fan at more than 50% without…
The existing Eufy baby cam holders that I could find on Thingiverse were hard to print, so I created this new one that is printable without any support. The clip is for 20mm boards and I used some felt to avoid scratching. If you have a…
I run a single cable drag chain on my RatRig V-core 3. The cable chain has some tolerances at each joint, which causes the chain to sag over long distances. To counteract this, I designed this ball joint mount to allow the cable chain…
Replacement for the metal lever on rat-rig endstops. Gives the enstops a longer throw without any rattling components and a softer touch than removing the levers. The arm length was chosen to hit the xy joiner, so no endstop block is…
This bracket holds my beer lines in place and prevents kinking. The beer flows through a coil in a cold water bath from left to right. The thicker tubes are a loop to cool the black insulated python hose so the beer stays cool on its way…
These are all currently available results.
