P
PrintablesTaable
Anycubic Kobra S1 Door Hinge Seal
Hinge seal for the Anycubic Kobra S1 to improve heat retention Recommended material is PETG, ASA/ABS, PLA Supports are required Total filament used is 2.5g
- Downloads
- 2,017
- Likes
- 303
- Rating
- 4.87
All models
Counting matching models…
P
PrintablesTaable
Creality Space PI - Vent hole plug
Quite often I leave the filament in the dryer for several days and I don't have time to let it dry again, that's why I need to keep the humidity level in the dryer low for as long as possible. Printed in PETG – if you plan to use flexible…
- Downloads
- 428
- Likes
- 74
- Rating
- 5
P
PrintablesTaable
Riser ACE PRO drawer
This is only drawer for ACE PRO RISER by Muflix. Model only for ACE PRO RISER by Muflix can be found here. https://www.makeronline.com/en/model/Riser%20ACE%20PRO/175423.html There are two drawer variants available: one with a 27mm depth…
- Downloads
- 104
- Likes
- 20
- Rating
- 5
P
PrintablesTaable
Kukirin G4 shock absorber hole plug
If you had to take apart the front/rear shock absorbers, you know that the holes to release the shock absorber are just covered with a sticker and re-sticking is not possible without glue, so I made a simple hole cover. Printed with PETG…
- Downloads
- 103
- Likes
- 8
- Rating
- 0
P
PrintablesTaable
Kukirin G4 stand support
The stand on the Kukirin G4 has no support and in the unsupported position it can slightly flop up and down and when you drive on a bumpy road the rear part of the stand always hits the lower part of the scooter's body. (and that makes…
- Downloads
- 94
- Likes
- 10
- Rating
- 5
P
PrintablesTaable
Wall mounted support for cat tree
Suitable for rolls with inner diameter 49-50 mm. In case you do not have a tight fit and the cat tree rotates on the supports. I suggest using adhesive tape and just wrap it a couple of times around the part you push into the cat tree.…
- Downloads
- 51
- Likes
- 19
- Rating
- 0
These are all currently available results.