7 models
Slice this file with the following magic setings to get a file you can use for tuning pressure advance with Klipper's TUNING_TOWER command: Overhang Wall Angle: 1° Overhang Wall Speed: 20% Zero infill Zero top layers Zero minimum layer…
Use your Presto food dehydrator as a filament dryer, without any destructive changes that would interfere with using it for its original designed purpose. Concept inspired by thing #4856292 , but redesigned from scratch. I really liked…
Introduction Remote direct drive extruders like the Flex3Drive (and its clone the Zesty Nimble) use large reduction gearing at the toolhead side to keep high torque from the extruder hob off the flex shaft. This has a side effect of…
The Recreator3D community cutter works well for cutting PET bottles for pultrusion recycling, but normally needs labor-intensive disassembly and reassembly to swap out the top part for different cutting depths, making it difficult to…
Simple double-cone tool that screws together from opposite sides of a filament spool to hold it for rewinding. Should fit most 1kg spools with 48-58 mm inner diameter and reasonable thickness, and most mini spools all the way down to 42…
This is a printable, parametric OpenSCAD design for ball-cup style delta joints, usable on delta-kinematics 3D printers or other delta robots or similar parallel mechanisms. It maintains a parallelogram configuration between a pair of…
This is a very minimal jig for sliding a cut PET bottle strip through to colorize it before turning it into filament with a pultrusion machine. Just hold a wide-tip permanent marker against the strip through the window and pull. The…
These are all currently available results.
