LayersFactory

All models

Sort order

Counting matching models…

P
PrintablesBurns3D

Print Flat Golf Tee

A print flat gold tee. Can print with 100% infill to make it bulletproof, but at 20% gyroid I haven't had any issues. Prints in 10 minutes on my MK4s. Happy golfing!

Downloads
315
Likes
32
Rating
4.67
Order a print of this model
P
PrintablesBurns3D

Comb for Roomba Brush

If you have long hair, you know how frustrating it is to remove it from the bristles of the Roomba brush. Here is an easy print comb to remove stubborn, wrapped-around hair from the bristles of the brush. Just take off the yellow bushing…

Downloads
54
Likes
15
Rating
5
Order a print of this model
P
PrintablesBurns3D

Decouvir Telescope Picatinny Sighting Rail

A picatinny rail to fit onto the HOROX Decouvir Maksutov-Cassegrain telescope. The adjustable crosshair sighting scope was being jostled too often, and I wanted to put a red dot scope onto the telescope to sight it. This also brings the…

Downloads
10
Likes
1
Rating
0
Order a print of this model
P
PrintablesBurns3D

Small Tap Guide for Flat Surfaces

A small tapping guide I made to keep the tap perpendicular to the object being threaded. It is septagonal, with each side labeled for a different size tap. Its numbers/sizes are: 6, 8, 10, 12, ¼, 5/16, and 3/8, all imperial. Printed in…

Downloads
10
Likes
0
Rating
0
Order a print of this model
P
PrintablesBurns3D

AutoMACs Orange Cover Reinforcing Bracket

I wanted a bracket to reinforce the orange cover on the Miltenyi AutoMACs I was using in the lab almost daily. It is easily broken if operators didn't lift the cover before pulling it out to load the conical tubes. Used a 0.4mm nozzle and…

Downloads
6
Likes
0
Rating
0
Order a print of this model
P
PrintablesBurns3D

Syringe Adapters for Prodigy Cell Handling System

An insert to allow the clamps on top of the Miltenyi Prodigy to accept syringes. Print can stay in place, and syringes can then be clipped in and out of the system as needed. I printed in PLA at 0.2mm height with a 0.4mm nozzle. No…

Downloads
6
Likes
0
Rating
0
Order a print of this model
P
PrintablesBurns3D

Water Bottle Handle

My finger would always get tired holding this bottle. clipping it with a carabiner worked, but then it was swaying back and forth, hitting by back or legs depending on where it was clipped. So I wanted to make a full handle so I could…

Downloads
5
Likes
1
Rating
0
Order a print of this model

These are all currently available results.