Counting matching models…
This is a razor holder that I designed for my wife so that her razor would have a home in the shower, and a spot to dry off after its use. Important: I printed it in the orientation shown in the third picture. No supports were required.…
A toaster tong...what more can I say. PETG is probably the wise move here. But a lot of filaments should work. Enjoy! Print Settings Printer Brand: Creality Printer: Ender 3 Rafts: No Supports: No Infill: 20 Filament: SUNLU PETG Category:…
I made this so that I could drape a net over our chicken coop area to keep predators out and not damage the net as it would hang over the T-posts. It is a loose fit so that it may fit a variety of sized of T-posts, but the walls are tall…
This is a cap to go over the end of a 1/4 inch NPT fitting on any of your pneumatic tools. I used PETG. I haven't tried PLA, but I don't believe it would be flexible enough for this design. The collar is just flexible enough with the…
This is an obscure and and odd part that perhaps no one will ever search for or print, but I designed it myself in OnShape because I couldn't find any aftermarket or even used parts online. Remington switched the the Outlaw model to…
This is obviously very specific to this Anker LC40 flashlight. Easy to print and a very nice fit. Print Settings Printer Brand: Creality Printer: Ender 3 Rafts: No Supports: No Infill: 20% Filament: SUNLU PLA or PETG Category: Tool…
This was my design made out of necessity to organize and keep in easy reach all of my small screwdrivers, pliers, hex wrenches, and picks. It uses 8x3mm magnets that you can buy for cheap by the hundreds on everyone's favorite online…
This Testors paint holder has 3 rows with 9 spots in each row. It holds the .25oz/7.4mL size Testors paints. In the model that I printed, I used support cubic to minimize the infill, but you could see the lines through the top layer. Not…
These are all currently available results.
