Counting matching models…
This design is a bracket for mounting an ebike controller box to the seat tube. My particular seat tube is 32mm in diameter. The controller was part of a Leeds ebike conversion kit. There are no pre-drilled holes for mounting the actual…
This is a basic stand intended to hold a dozen bean cellar containers from Weber Workshops. It's specifically designed to work with their commercial plastic version, unsure if it works with the consumer glass version. Print Settings…
This "puck" was designed to adapt the Decent Portafilter Stand, when used with the Niche Zero mounting location, to accommodate the exposed screw head so that the stock grinder collection cup could be used hands-free as originally…
I designed this protective spacer to mount to my Surly Bridge Club downtube as a guard against rubbing from the CYC Photon motor. Its diameter is slightly larger than the actual downtube, allowing room for a rubber shim to provide more…
This mount fits the Divide bike rack from Old Man Mountain and is intended to support the horizontal installation of a Cygolite Hotrod tail light. I printed this on its side (for added strength) with a support overhang angle of 60 degrees…
Moen's Attract with Magnetix shower head comes with low pressure fittings in the grip. This causes water pressure that is too low for most consumers. Conversely, removing the fitting entirely results in excessive pressure that can also…
Replacement clip to hold a MySmartBlinds solar panel in place. Prints without support. Note that unlike the original clips provided by SmarterHome, these clips do not adjust length . I designed them to the approximate length that my own…
This wedge is used on either side of the REP x Pépin dumbbell shuttle to keep it resting in place. It was designed as part of a DIY dumbbell stand as explained here . Two wedges are used for each shuttle and screwed into the underlying…
Ergonomic grip that slides onto the handle of the American Barbell V-bar tricep attachment.
Bracket used to mount a small water cooling reservoir inside the NR200 case. Designed specifically for the EK-RES X3 150, a standalone reservoir (no pump) that fits inside the NR200. Should fit GPUs up to 295mm long in the vertical…
Remix of the original 3-prong GoPro accessory mount with adjusted hole positions for the US-made Divide rack.
I designed these models to allow me to move the tablet to the rear of the chassis, allowing easier access to cups. I use one 3M control strip under the stand to keep the base firmly planted, and another one with a hook for routing the…
These are all currently available results.
