Counting matching models…
Yet another version of bricks to create bridges with IKEA Lillabo tracks and DUPLO bricks. Designed for an inclination of 2 DUPLO heights / 20cm track. Floor->Slope (bottom) Slope->Slope (middle) Slope->Bridge (top) Bridge->Bridge…
Small "wrapper" for mounting the cheap 9g Tower micro servos on LEGO. It will NOT hold itself on like actual LEGO, but when you have bricks all the way around it, it will sit securely. Includes 24 and 19 tooth gear, but only the 24 is…
Misc. hooks for the kitchen table rail or the cabinet door gaps. I have made two versions of the hook for the door gaps. The thin version fit smaller gaps. I can also recommend the headrest mounted hook I have created:…
A mosquito net for the VW California that is mush easier to both store and mount than the original one supplied with the camper. Easily fits e.g. up against one of the sides in the drawer under the bench. No need to be flat on the bottom…
-Print -Insert SB50 pole in the hole -Insert two (sacrificial) M4 nuts in the slots in the sides -Rest assembly on big vise -Insert stripped cable in pole -Squeeze till the nuts are flush with the tool -Release -Somehow dig out the now…
Replacement chain end stop for Bosch COMFORTLIFT GTF-27L / GTF-40L. The clips are more stiff than the original, so it is a more difficult to mount, but it should also sit more securely. UPDATE: So far I have only test fitted an earlier…
Two inserts for the shelf(?) below the mirror on the closet door. These will help toothbrushes / toothpaste stay upright. The toothbrushes can still wiggle around, but at least they are somewhat under control. The H-shaped divider goes in…
Tiny clips for holding two LED strips parallel. May be glued to a surface and make it possible to click LED strips in and out. Print vertical on the side, like the loose clip in the picture. Carefully slide the LED strip into the slot and…
The lid that come with the french press set for Primus Eta / Lite can be twist-locked on the bottom of the stove. This thing makes it possible to click the lid and the filter together, so they both can be twisted on the bottom of the…
Print each part flat. Glue the "hook" part to the "bottom" part. Cut a suitable length of strap (e.g. from an old rucksack). Loop the strap through the top and bottom parts. Sew the strap to capture the parts. Lift the headrest from the…
I have two sets of Jabra C820s and some of the original plastic got really brittle. After using zip-ties and glue for some time, I finally decided to design yokes to replace the parts that were falling apart. The replacement yokes offer…
These are all currently available results.
