Counting matching models…
The Hadley telescope by Maff is a great design that allows makers for an easy and cheap introduction to astronomy. There are lots of difficulties when using a telescope for the first time, for me one of them was trying to take a picture…
These templates will fit perfectly onto the uncut headstock so you can mark the line to cut. If you print two templates, mirrored in the Z axis, you can mark it from both sides. That should give you a reference to cut and sand at a right…
Elevated stand so you can place another device bellow it and pass the cables from behind. I tweaked the height so it works well with my MIDI keyboard, but will also work when using two Airas together (see pics). It leaves enough space…
A simple and easy way to mount a DC switch to a panel, specially if you can't mount it through the panel due to the panel thickness. It only uses one M3 screw for mounting so it is very compact. Print with 100% infill and 0.2 layers The…
This is a clamp for 25mm diameter corrugated tube. You just need to print two times the same model and they join using M3 screws and nuts clamping the tube in the middle, thanks to the ribs on the clamp the tube can't slip. Using the…
For use with 8mm adjustment screws, but can be easily modified with the included FreeCAD model. For me a 30% infill worked fine, but could be printed at 100% if you need extra strength! Can be printed flat on the bed without supports.
This is a simple and compact clamp to mount a male XT-60 connector to a wall or panel of your project. This will help you connect and disconnect a battery easily. The clamp has a retention tab that will prevent the connector from sliding…
These are all currently available results.
