Counting matching models…
A quick printing case for the Raspberry Pi Zero 2 W The Zero 2 W is a great little workhorse but who wants a bare board sitting around? Cover it up with this minimal case. This case is primarily printed flat with fold lines designed in…
This paper towel roll holder is designed to be as minimal and easy to print as possible. The STLs here are designed to fit into a 1" centre-to-centre 1/4" diameter pegboard. Everything in this model is configurable in OpenSCAD (see below…
I got tired of my portafilter being unstable and having the spouts touch the bench. So, I made this stand. The spouts nest nicely in the base and the extended arm cradles the handle for a level portafilter. The spout are cut out to each…
After a while you accumulate a ton of these little hex drivers and it's really hard to find a holder that can accommodate both long and short bits. The top row of this model is designed for longer ones and the bottom row for driver-only…
A very light remix - this removes 1mm from the counter sink meaning that short screws actually reach the receptacle.
Crimpers are hard to mount to a pegboard. They're big, weirdly shaped and have no obvious mounting holes. Additionally, you often get interchangeable dies which are easy to misplace and don't have good ways to organize. There are two…
The great Grace Hopper gave away lengths of wire to illustrate the distance light could travel in a single nanosecond. I needed to illustrate something similar in a presentation but showing a wire on stage isn't very visible. So, I made…
These are all currently available results.
