Counting matching models…
This DeWalt 20V battery holder mounts to the wall and positions the batteries horizontally at a slightly upward angle. This allows for the batteries to be stored closer together than the traditional vertical holders. Other battery…
This Milwaukee M18 battery holder mounts to the wall and positions the batteries horizontally at a slightly upward angle. This allows for the batteries to be stored closer together than the traditional vertical holders.
This is a replica of the large bleed block that comes in the SRAM bleed kits. It is intended to be used with SRAM Code RSC and SRAM Code R brakes. DB8 compatibility: As reported by @Radek, this bleed block can also be used with SRAM DB8…
This is a replica of the four piston bleed block that TRP sells. It is intended to be used with TRP DH-R Evo and TRP Trail Evo brakes but may work with Shimano four piston brakes as well since they use the same pads. Printing Instructions…
This is a tape holder that is compatible with Sy's Peglock - Locking Pegboard System . It's designed to be used with 3/8" dowel rods. Inspired by this model . Printing Instructions Rafts: No Supports: No Resolution: 0.28 Infill: 15% Wall…
Sy was nice enough to provide the .f3d file for his amazing pegboard system . However, judging from the comments on that model, it seems that some people are still resorting to scaling the entire model rather than adjusting the relevant…
This Worx PowerShare 20V battery holder mounts to the wall and positions the batteries horizontally at a slightly upward angle. This allows for the batteries to be stored closer together than the traditional vertical holders. ***PLEASE…
This design uses a single 8in zip tie for attachment to the helmet. I also put a single strip of electrical tape on the side of the mount that contacts the helmet to help keep it from moving around while riding. Printing Instructions…
I created this to mimic the centering tool that Park Tool and BIKEHAND sell to perfectly align their wheel truing stands. For the long arm, attach a length of 2020 aluminum extrusion by either: Fastening from the top by tapping the center…
These are all currently available results.
