Counting matching models…
I want to use a Sonoff SNZB-04 Wireless Door/Window Sensor outside to check on the status of my yard gate. I neither trust the original case to be wind/water/weather proof, nor do I believe in sticky tape (especially outdoors). So I made…
I used a Gridfinity Creator 5x3x2u Solid Bin as a base to create this Kindle bin. The kindle is pretty much exactly as wide as 3 units, so there is very little room left for walls. In my print they are just one wall and it can be a bit…
My new PB Swiss Tools - 8249 - SwissGrip set arrived and so of course I needed to model something for them. I also added four ballpoint hex to my set (PB Swiss Tools - 8206.S4-120/S5-140/S6-160/S8-180) so you will find those as well. I…
My contribution is pretty much non-existent, I'm just uploading to save the next person a few clicks. All credit goes to @AMacG Opened FreeCAD and adapted the angle, as instructed by the original author.
I was trying to use a Sonoff SNZB-04 Wireless Door/Window Sensor for my heavy sliding garage door, but sticking the contact onto a wooden frame – forget it. Also, the tiny magnet in the original contact was way too sensitive for my use…
Based on the https://gridfinity.bouwens.co/ 1x1x3u solid bin. The magnetizer is 40.5mm in diameter so it almost feels like it was made to fit in a bin :) One version that's flush with the top, and one version that's stackable.
Exactly matches the Aqara Wireless Remote Switch H1, so that only the buttons protrude. Printed with white Bambulab PLA Matte. Ironed the topmost layer. Posted the entire Nightstand project on Reddit .
These are all currently available results.
