Counting matching models…
Jaguar XF X250 right hand drive (UK, Cyprus, Aus, Japan etc) phone holder for a BV9900 phone. None of the designs i could find allow the odd shaped "cubby" to be closed when not in use, this design does, I've spruced it up a bit with a…
Jaguar X250 lock cover/bezel, not an exact match but I think you'd probably get away with it, I think this is a Volvo XC60 and a few others and can be popped off to access the door lock with the blade key. I did test this and it does pop…
I got a GIVI tank bag from a pal for a couple of quid, problem was he'd thrown out the flange (suppose that didn't matter as it wouldn't of fit my bike anyway!) and unfortunately the plastic GIVI tank mount I think original part…
Kenwood Chef A701a front attachment badge cover a.k.a slow outlet cover, this sits at the front and can be removed to attach the sausage maker. If your looking for an exact copy, this isn't it as its quite an odd shape, I couldn't get a…
A few 3d printable replacement parts for the Kenwood A701A (1980's) stand mixer - Misc: top_spindle_cover is the cover for the juicer attachment, my chef didn't come with one, helps keep muck out, printed in PETG but anything will do…
A rear brake guide that fits the mounting bushes on HEL Performance, It will probably fit the old brake lines as well. Easy to print without supports in PETG, print with the fonda text parallel to the print bed. Colour matching optional…
The original rubber brake line setup has a hose line splitter mounted on the right mudguard, new braided steel brake lines often come as a “race” setup, two separate lines meaning the splitter isn't required nor useable as a mount. This…
Yet another kenwood mixer feet, this fits A701a (1980's), I printed it in TPU, the finer spike will possibly fail but it turned out they're not required at all. The original design had rubber feet that where held in place with expansion…
This design allows my cheapy Ebike controller display with small non adjustable 22mm handlebar attachment to fit my road bike handlebars which are kind of a weird oval profile and much bigger than the cheap moutainbike handlebars they had…
Ball mount adapter for the excellent quad lock design by suxfevi, I use this to attach to 12mm ball stem for my motorcycle, use screws in the little holes on the bottom to tighten down on the ball Category: Mobile Phone
Feet for the Kenwood Chef A701a (1980's) stand mixer, these feet are need to provide an airgap for the motor to draw cool air from, printed in TPU, it doesn't matter about the little spike at the top, they should be tight enough to hold…
Ikea Tradfri remote replacement to fit Schneider Lisse white moulded plate switches, there's a few variations but I only actually use the E1743 full and cut design, the steering wheel design kinda worked but i found the remotes poor and…
The Polycarbonate end that came with is Sous vide broke almost instantly, unfortunately its also acts as an impeller housing, meaning without it the water isn't circulated. Epoxy worked for a while but ultimately replacing the part was…
This is a design to hold the Topsflo TS5 pump commonly used in homebrewing under a table. V1 design: Fits the earlier revision with a notched design, this will work if your not pumping hot liquids, t V2 design: was for a newer revision of…
These are all currently available results.
