P
PrintablesBlamm
Flagpole clip to hang half-mast/half-staff
Made for a 27.5mm diameter flagpole. Prints without support and uses an M5x12 or 16 BHCS with accompanying M5 nut.
- Downloads
- 68
- Likes
- 10
- Rating
- 5
All models
Counting matching models…
P
PrintablesBlamm
Herman Miller Mirra 1 - Tilt Lever
Uses a single M3 Brass Heatset Insert (M3x5x4 ) at the end of the shaft and an M3x8 SHCS, to screw the paddle to the shaft. Built in support on the shaft, should break right off after printing
- Downloads
- 57
- Likes
- 1
- Rating
- 0
P
PrintablesBlamm
Slimmer version of CNC Kitchen TS100/101 heat set insert tip storage
The original did not fit in my cardboard tube, so I decreased the outside dimensions a bit. Internals are identical.
- Downloads
- 55
- Likes
- 4
- Rating
- 4.5
P
PrintablesBlamm
Delta Flyer - E3D Revo Voron mount
Adapted the existing hotend mount to fit a Revo Voron by E3D. It uses a PC4-M6 coupler to hold the PTFE tube.
- Downloads
- 28
- Likes
- 11
- Rating
- 5
P
PrintablesBlamm
Klicky Probe mount for the Delta Flyer printer
Mount for the regular Klicky Probe to the Delta Flyer carriage. There is no dock (yet?) so it will have to be attached manually before any probing is done. Very useful for doing the delta_calibrate for example, but you can also do a bed…
- Downloads
- 16
- Likes
- 8
- Rating
- 0
P
PrintablesBlamm
Delta Flyer KnomiV2 mount - Delta edition
Because every Delta loves more triangles! The design by Keep was great already, did some small changes to the backplate so you don't need to drill a cable hole in the lid anymore. Also added counterbore bridging to the screw holes so they…
- Downloads
- 11
- Likes
- 4
- Rating
- 5
P
PrintablesBlamm
CW2 PUG Compact Mount - Dual PUG
Twice the PUG, twice the fun! I needed it to route a separate Beacon cable next to my toolhead cable
- Downloads
- 10
- Likes
- 1
- Rating
- 0
These are all currently available results.