7 models
Support required under the letters. Use smart fill to paint on supports Vinyl sleeves are light so you can use double sided tape to stick to cabinet or wall. Or create your own holes in Prusaslicer for a stronger fix with screws.
Converter that fits Australian painters pole thread to a standard 5/8th 11 thread used by surveying equipment. A painters pole is a cheap alternative for extending your radio aerial nice and high. Print instructions I have had success…
Put the lid on to shake out all the nut crumbs from the bottom of the container. STL included but make sure to print no bottom and top layers on the first 3mm of the print.
Doing upright rows with my EZ curl bar meant that I was hitting my forearm with the weights. I created a 75mm spacer which allows more room.
I had a half functioning Trimble bipod that required some additional bits. A quick measure up and a bit of design in Fusion 360 and its now working great. Prints were done in PETG and are working great. The button measurement is 20.75mm…
This mount will fit the standard tribrach base. I have printed in PLA with no problems at 0.3mm layer height. Printed in this orientation with painted supports works great and is a snug fit.
There are 1cm notches marked all around. The upper taper is 45 degrees. This tools enables you to transfer square lines around a 90 degree bend.
These are all currently available results.
