Counting matching models…
This modified version uses M3x12 bolts instead of M5s, as M3s have by far enough strength to hold the weight of the printer. Also, I did not have M5 blots and nuts laying around. BOM (per handle): 2x M3x12 bolts of any type 2x 2020…
Use black as a base and white as the top. The two middle colors can be any darker green and a lighter blue. Print with a 0.16mm base layer and 0.08mm layer height, 100% infill and 1 perimeter. Start with Black At layer #7 (0.64mm) swap to…
Can be screwed to a desk, piece of metal or anything. Holes are 4mm in diameter. To fasten the motor use 2xM4 bolts of desired length. Print with the front laying flat on the printbed, no supports required. Can be printed with pretty much…
Designed for this (or this )type of switch. There is also space for 3 ~14AWG wires to come out both sides.
I did not have anything to fabricate a better solution, so I came up with this. These won't wobble as some of the other printable ones, yet they nicely reduce vibrations transmitted to the surface the printer sits on. It should have a…
Passive cooling upgrade for the non-pro Ender 3's power supply. I have made it a year back, and have been using it since, without overheting, in an open enviroment witohout much draft. I did many 12+ hour prints without any problems,…
It can be screwed or glued with double sided tape to anything, I made it specifically for the small space between my whiteboard and wall. It can hold 4 banana to crocodile test leads much like these and 4 Rigol oscilloscope probes that…
Screwholes are 4mm wide. Can be used with the same screws for GoPro mount as the default ones.
Battery powered lab bench powersupply, with a max output of 36V/5A and 80W total. It has a battery voltage meter on the right side and a 60mm fan on the left, that is connected to the fan output of the XYS3580 module. The battery balance…
Covers the QR code on a stock Ender 3. Looks cool. Print it. Fastened with cable ties.
Use black as a base and white as the top. The two middle colors can be any red and vibrant yellow. Print with a 0.16mm base layer and 0.08mm layer height, 100% infill and 1 perimeter. Start with Black At layer #7 (0.64mm) swap to Red At…
It was designed for a Himoto HI2101, which uses a 12mm (inscribed) diameter hex nut and an M3 bolt for fastening. May fit other rc cars too, i only had this one on hand. You can put supports in the hole in the center for better surface…
The hexagons on the top are sized so that V6 nozzles can lightly screw into them. The 2 hangers on the back are spaced so that a 7mm wrench can be hanged from them, for changing nozzles. Print with 3 perimeters so that the top layer is as…
These are all currently available results.
