Counting matching models…
Thanks to @QED_Maestro for his brilliant idea of simple tweezers for one handed measurements. Now optimised for BSIDE DMMs. Compatibility: A10 S10 S11 S20 not with S30 / S30X In the photo is the RC ;)
For Creality K1 Max as it uses the same location mounts as the original PCB. 4x M4S (l=4mm) heated inserts needed The input is quite easy - BED connector: 1st pin = “red” labeled - unused 2nd pin = “+” positive 3rd pin = “-” negative 4th…
STEP file Remix from the original step file from respected @Henlor and his mod https://www.printables.com/model/615689-creality-k1-xy-belt-tensioners-upgrade. As mentioned in another remix - 20mm are more common.
Based on Henlor 's masterpiece. Designed for Mellow's/VzBoT's T8 Oldham coupler (22 mm diameter). BOM for one carriage: 2 x M3 standard heat insert (M3x4,6x5,7) 2 x M3x6 I used PA6-GF25 for V1 and managed to press the bearing into the…
Based on Alexander's model, but made it shorter for better air circulation inside the PolyDryer. Also my lid has smaller opening (you can use my tray with the original lid). Ready to print. You do not have to change the layer settings.
Inspired by DerrickDarrell 's Oldham coupler mount but with the manually adjustable Z axis. Based on @JEng CAD files (V2) and drawn from sketch - still in STEP files. Tolerances checked according to JEng's files based on Henlor 's…
A stronger , printable 1.5GT timing belt retainer. Independent R&D, thanks to Henlor Easy to print with no supports. It works better for me than 2GT retainers :) Hight temp filament strongly recommended. V1 - alpha V2 - corrected…
I tried to make the nut trap as small as reasonable. The is only little force along the screw so the nut trap can be lightweight. M3x10 (suggested wafer (ultra thin flat head) screws) M3 thin nuts (h=1,8mm) standard will also be OK
This is a remix. I needed to make it fit with my FNIRSI HS-02A soldering iron with CNC Kitchen C245 Installation Tip Adapter . I can highly recommend this set! :) Made for M3 x 20 and M3 nut. I printed the v8 with PA612-CF and it requires…
Originally designed for Grünig + Elmiger (G&E) tube but it can be used as an adapter for any type of the Scatt mounting kit. Normally the target is invisible for the Scatt when it is mounted below the barrel and you aim at 2,5 m. I chose…
PSU Holder to keep it in one place.
Note: this is only compatible with K1 Max printers that have done a gantry swap (like the BootyJones gantry). This will not fit stock printers due to the location of the tensioners on the stock setup. This one has M3 insert to screw it…
Remix of the great model. A use original. B&C with thinner wall between. Width corrected. D: smaller file and built-in text component.
These are all currently available results.
