Counting matching models…
Introduction I love this design. It's great, but I had some issues I needed to address. Thank you to GunplaMark for making my life easy by publishing the STEP files. I've made a number of changes from the original design: The original…
Ok, you know what? Don't download this. Get this instead.. This is way better: These work with the Gridfinity Bin with Printable Label by Pred (parametric) I've made a number of changes from the original, but I'm also including the fusion…
Card holder I designed for my wife to display her cards. It's a good width for most cards, and since the sides are open, it will also hold wider/larger cards too. Fusion file included if you would like to modify the design. Recommend…
Changes from the original: Removed the letters on the front and decreased base thickness to 0.6m. This alone saves about an hour. Added a 2mm chamfer to the base to decrease chances of lifting at the corners while printing. Print with 0.2…
Introduction First: This has not been tested at large scale yet. I would be curious to hear from anyone who tries it for a print with a large (1000+) number of toolhead changes. In my in-machine testing, it takes about 300 tool changes…
Introduction This is a mod for the Hill Mount or "Strurdy" Mount to add a worm gear to gradually adjust the altitude of your Hadley scope. The use of a worm gear accomplishes a couple of goals: High gear ratio and minimal backlash,…
After throwing pots, I cover them with plastic to slow down the drying process. Far too often, I end up deforming the rim of the pot with the plastic. I designed this frame to sit over my pots and protect them. Print 4 of them and then…
Fully parametric design. Fusion file included as well as 3 objects with some typical hole spacings: 76mm (3") 96mm (3.75") 102mm (4") See the screenshot for parameters you can tweak in the model. The holes are sized to self tap an M3…
Fully parametric design. Fusion file included as well as 3 objects with some typical hole spacings: 76mm (3") 96mm (3.75") 102mm (4") When I printed this using PLA Silk, it shrank a bit, so I've included each model at +1mm sizing as well.…
I already had a ton of swatches from this design by @SheepMe. The dimensions are slightly different than the holder in @GunplaMark's design, hence this design. Two versions, one with the internal space for an RFID tag and one without.
After the magnets failed to hold it properly and the camera fell, ruining a print, I decided I wanted a version of this which could not detach. It uses a single m3nS nut. You'll need to replace the m3x4 socket head screw which comes in…
3 sleeves. The UTA interface has one side which meshes with the UTA. The LTA interface does the same. The "Basic Sleeve" will connect to both (albeit in opposite directions). You can print as many Basic Sleeves as you can fit. To install,…
Case mount for the Flirc Raspberry Pi 4 Case. No supports needed.
The 300mm length version of the IKEA Skydrag was on sale, so I bought a bunch of them. This is a very simple model which slides onto the end of the original mounts and then screws perfectly into the mount holes on any vertex of the…
These are all currently available results.
