Counting matching models…
This holder mounts in the frame just behind your camera, allowing you to install very securely a large capacitor that would otherwise jiggle inside there and potentially cause a very bad short. My capacitor is 18mm in diameter, and the…
Slicer: Created and tested using OrcaSlicer 2.3.1 . (I am personally using this version because I've run into too many issues on the latest OrcaSlicer releases, but the file should open and work perfectly fine on later versions as well).…
Keep your FPV build clean and your antennas secure with this integrated dual-antenna mount. Designed specifically for the TBS Source One V6 frame, this single TPU print holds both your ELRS T-antenna and your HDZero U.FL video antenna…
On the SHT36v3, contrary to manufacturer's instructions, be sure to specify in your config : [lis2dw] cs_pin: SHT36:gpio12 spi_bus: spi0_gpio4_gpio3_gpio2 axes_map: y, -z, x
I couldn't find any remix of the hotend mount to fit this chinese version of a "v6 CHC" hotend, which seems to be some sort of revo-style hotend, with standard v6-style swappable nozzles. This little beast exists in 24v and 12v with some…
This spacer is intended to be printed in TPU. Holes are spaced 20mm apart, and should fit M2 bolts. I use it to raise an Avatar Pro HD VTX in an Apex 5in frame, therefore allowing much more airflow around the bottom heatsink. Temperatures…
This insulation plate is made to protect the bottom caps on larger 8bit SpeedyBee ESCs, by keeping them from making contact with your frame. Hole distance is 30mm. Plate is square. Print in ABS or TPU, hot so that layers are really…
These are all currently available results.
