P
Printablesjaguar
Muddy Hunting Blind Hub
I recommend printing this with a strong TPU at about 50-80% infill to give it the strength it needs in the flex.
- Downloads
- 327
- Likes
- 17
- Rating
- 0
All models
Counting matching models…
P
Printablesjaguar
Ski/Pole Holder
This holder is standardized for ~80cm wide ski's and ~18mm wide poles. I recommend printing out of PETG.
- Downloads
- 249
- Likes
- 30
- Rating
- 5
P
Printablesjaguar
Ceramic Forming Tools
Supports are required because not all parts of the model will touch the bed (because of the ergonomic design) and the overhangs are drastic. I also recommend printing them with a brim to prevent the parts from peeling up.
- Downloads
- 175
- Likes
- 44
- Rating
- 5
P
Printablesjaguar
Antique Tractor
This is an old two cylinder tractor made to represent an early John Deere.
- Downloads
- 94
- Likes
- 20
- Rating
- 0
P
Printablesjaguar
Drill Bit Index
The slots on the back are for optional wall mounting for ½ in studs. The holes for the bits are modeled with a .01 tolerance for printing.
- Downloads
- 68
- Likes
- 12
- Rating
- 0
P
Printablesjaguar
Fletching Marker
The hole for the arrow is 7mm and it works for my 4mm inner diameter arrows which are closer to 5.8mm outer diameter. It has a notch on the end to slot into your knock and line up the vanes properly. Print it vertically so you won't need…
- Downloads
- 50
- Likes
- 5
- Rating
- 5
P
Printablesjaguar
Arrow Puller
I printed this out of PETG for some added strength and added some foam inserts to grab hold of the arrow. I use it on my 4mil and 6.5 mil arrows but it should work with any size. For the pin in the joint, it’s just long enough to reach…
- Downloads
- 48
- Likes
- 11
- Rating
- 5
P
Printablesjaguar
3D Printer Nozzle Case
Has various holes for the nozzles, I used a toothpick for the hinge pin but there is also one in the .3mf file.
- Downloads
- 33
- Likes
- 11
- Rating
- 0
P
Printablesjaguar
Argon Collets
I printed these out of PETG with 10 inner and outer walls at 40% infill on a Prusa mk4. A few varying sizes for 2.5in and 3in pipe with different inlet holes.
- Downloads
- 23
- Likes
- 10
- Rating
- 0
P
Printablesjaguar
Dovetail Sight Mount
This is a dovetail mount I made for my Axcel Landslyde and it also fits my Sure-Loc sight (might fit others too). The set screw hole is “tapped” to 5/16-24.
- Downloads
- 22
- Likes
- 6
- Rating
- 0
P
Printablesjaguar
Rasberry Pi Camera Wall Mount
Used this to mount my rasberry pi's camera on the wall to monitor my printer
- Downloads
- 13
- Likes
- 7
- Rating
- 0
P
Printablesjaguar
Cable Holder/Organizer
I made this to organize my lightning cable and 2 USB extensions.
- Downloads
- 4
- Likes
- 3
- Rating
- 0
These are all currently available results.