Counting matching models…
This model was redesigned using FreeCAD. Added features: - higher front part holding the book open - cuts for better stability Can be printed quite well without supports with 3 perimeters of 0.3 layer height.
This recessed rack ear is a (hopefully) improved version of the one made by cedd. The original suffered from too much flex when mounted in to a 19" rack, leaving an impression that it will bend over time or crack when not handled with…
Custom foot for a common type of arm lamp (e.g. TERTIAL by IKEA).
I made this model to use my Sony SRS-XB100 as a portable omnidirectional speaker for room acoustic measurements using Room EQ Wizard or custom routines. The extended base includes several features: Slots for gluing in the 5/8 to 3/8…
The original Micron+ door corner magnets did not work well for me - fasteners reacted too much to the heat inside the chamber. This latch uses 4 6×3 mm magnets glued into slots in order to hold strongly. The frame part is press-fitted…
This Babybay bed side table makes use of the baby bed frame to secure itself in place and helps to keep your things close when needed. Printed with PETG without supports (5 perimeters, 30% cubic infill). Additionally, the bracket can be…
The original plate base dimension is 45.1×44.2 mm. Thanks @PavelLukes for precisely modelling the Peak Design plate , which served me as a basis for this model. The Peak Design plate snaps tightly into the adapter, there are little to no…
These are all currently available results.
