Counting matching models…
This mounts between two sections of solderless breadboard to allow using carrier boards or modules with a wide row spacing, for example an ESP32 module. Includes dovetail slots/pegs to fit the solderless breadboards I have (should be…
This is a ventilated mounting bracket for a DHT22 Temperature+Humidity sensor, with an integrated connector that the DHT22 plugs into. It uses standard JST-XH 2.5mm crimp pins. You can find these at about any electronics supply house.…
Just a battery holder for AA and AAA cells. My FreeCAD design file is included. Category: Hobby
This is a connector housing for a standard Rotary Encoder with built-in pushbutton switch. You can find these at about any electronics supply house. Note: You will need JST-XH (2.5mm) crimp pins, some wire (I used 28 AWG stranded) and a…
Battery Holder for 18650 and 14500 size cells, with screw slots for wall mounting (or just set it on a shelf with or without little rubber feet) You may want to print it with support for thin walls. My FreeCAD design file is included.…
This is a screwdriver/nutdriver for standard 1/4-inch drive hex bits, with a rotating cap. If you need to scale it to fit a smaller or larger size bit, first print the Test Piece to get the scaling right. I had to be careful pushing the…
This is a Bumper Case for a Texas Instruments SR50 (or SR51A) calculator (from the mid 1970's) I printed these in 2 types of flexible filament: Gizmo Dorks Flexible TPU - TPU with a shore hardness of 96A 3D Solutech Real White 1.75mm…
These are all currently available results.
