Counting matching models…
Remixed Crusibal's fender hook to be stronger. His would snap where the frame rail curves on top when weight was put on it. This now matches the curve of the frame rail, and has a buttress that extends inward to brace it against the…
A few features I put into this: 3mm pilot holes in the disk head can be tapped with a 3mm tap, (or just warm up some M3 screws and screw em in). These are for M3x5 or M3x6 Socket Head Cap Screws, which fit into the guide holes on the…
Cupholder designed to fit the rail clip designed by Crusibal. Cupholder is printed standing upright, with support for the square block that interfaces with the rail clip. I printed in ABS. For the drink supports, print two copies of…
The model is one STL, but can be split into parts/objects to print the body and the tabs separately, helpful if your supports aren't perfectly dialed in. The parts can then be glued into the body, (I used ABS glue…super glue, solvent…
Was tired of my MK8 GTI carplay flaking out while driving. This uses a magsafe charger off of amazon to hold the phone in either orientation above the car screen. Phone uses bluetooth to talk to car radio, so all functions (music, siri,…
The Jayco 242BHS / 242BHSW doesn't have an AC vent in the lower bunk. It does have an AC vent in the ceiling of the bathroom, but the bathroom is so small that it ends up damn near antarctic in there. So I made a plenum. You pop off the…
Torklift's EcoHitch is great for the MK8 VW, but has no place to mount the stock mobile antenna that's on the crashbar that you remove for installation. Modeled and printed this to put the antenna back in it's standard location. Printed…
These are all currently available results.
