Counting matching models…
Made these blocks to ensure the Ender 6 X gantry is square to frame. Print 2; one for each side. Simply place on top of the front upper 2040 rail, pull X gantry forward till it touches the alignment blocks. If only one side touches, then…
Uses Grandma's Favorite Filament Clip classic model, and added text via prusaslicer add part>text option. Includes PLA, ABS, ASA, PC (PolyCarb), BP (3DTomorrow BioPro). if you want to add more, i used the following settings: Font: Noto…
Modelled on the SMT1500RMI2U bracket, 870-6857A-002 JY-REV02. This is not intended to be used to secure weight but mearly stop the UPS from sliding about on its rails and ensure it's located in the correct position. Original screws: 8-32…
Wall mount for the Eaton 3S Mini UPS. I used regular countersunk screws in upper holes (4.5mm). All holes are spaced at 60.3mm which is UK 1Gang Socket screw spacing, which allows mounting to a wall box (use the lower holes which are…
I had an unfortunate mishap with the genuine mastercore reusable spool solution where the cardboard side came off. Filament everywhere and became knotted. This design should stop that. Design should be self explanatory. notes : 4mm reel…
SFS v2.0 mount to fit to the original E6 filament sensor mount. This raises the mount point as i found the original one ran too close to the filament spool and wouldn't always allow the filament to unwind nicely. SFS can be mounted either…
should print fine with any layer thickness (i've used 0.4 & 0.32mm). width 50mm length 130mm height 30mm 29March'22: model slightly updated from 50.5 to 50mm width as some of my bins seem narrower than others. Also added a new model with…
uses upto 5 6x2 magnets. 3x card standoff holes are for m3 heat set inserts. Expander does get warm so might not be suitable to print in PLA. Print with enough walls/add modifier so the top 3 standoffs are printed solid.
where our BT master socket is mounted on the inside wall is slightly damaged causing the socket to not mount correctly. So i designed this to allow correct tightening and further damage to the wall. Design has a slight recess to allow the…
Tons of calibration cubes around? might as well put one to a use… this is a base for 4.9mm extruder rods which simply presses onto the end to visualise the movement. Simply superglue your chosen right-angled model into the triangular…
In my past (unpublished) revisions, PLA has worked for 2 years of winter use. I've now beefed up the legs so they're not so fragile and break and a few further tweaks to stop it being as loose. I'm now using 3dtomorrow's BioPro as an…
replacement center cap for 2Forge ZF1 (and maybe other) wheels. flush fit I've printed with black ASA, enough walls so the rear legs are solid.
Version2 has been updated. mid plate does not secure itself to any part. It simply gets clamped between the MGN12H block and the Hermit crab. Full range adjustment on the Hermits H2 slot holes. Modelled (but not remixed) with help from…
used on https://www.thingiverse.com/thing:4354970, but should fit up/downstream remixes. Bracket simply push-fits into the existing hex holes and can be orientated across any 3 adjacent hex's. requires 2x 6x2mm magnets per bracket. I used…
used to mount a Lenovo TB3 dock to a generic pole (29mm diameter) vesa mount. this mount moves freely on the pole, with my dock resting freely on the arm bracket. If you need it to be securely fixed, then this wont work without additional…
These are all currently available results.
